This Z-Wave.Me switching Flush-Mountable consists of standard DUWI Z-Wave hardware but located with an enhanced Z-Wave.Me firmware. The  pattress box Flush-Mountable from Duwi is intended to control window or door blinds.  A 230V powered pattress box is needed for installation. The Flush-Mountable has two buttons. In order to use them for local control the insert needs to be completed with a switching paddle and a mounting frame of one of the Duwi switching series “Everlux” or “Arcada”. The unit is designed for use within a 3-wire system, which means that a neutral wire (blue) is needed for operations. The motor of the blind is connected to the control by two wires and the neutral wire. It will be included and controlled in a Z-Wave network from a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.

Compared to the standard Duwi firmware this product offers a series of important enhancements.

• Works well within networks controlled by an IP gateway
  • status changes are reported back to IP gateway in real time
  • switching paddles can be used to control scenes in gateway
• Implements the most recent advancements of Z-Wave technology Explorer Frame for network wide inclusion and automated reconfiguration of networks
• Improved routing algorithm for faster communication
• Prevention against „Ghost Nodes“ after controller reset

Further enhanced features include

• Configurable night light
• Three association groups (single click, double click, status change)
• Switching paddle can be used for control independently of local operations

Technical Data:

• Power rating: 230V, 50 Hz
• Switched load: up to 1800W motor
• Outputs: 2 switches interlocked against each other
• Duration of switching signal: 2 min.
• Local interaction: 2 buttons for inclusion, exclusion and association
• Dimensions: 48mmx52mmx27mm
• Wireless behaviour: receiver
• Z-Wave type: slave
• Power supply:  via 230 V power
• Distance: up to 100 m outdoor, up to 30 m within buildings