The HRT is a system to control warm water heating in general and floor heating installations in particular.  It consists of a battery operated wall thermostat installed in the room to be controlled and a relay switch to operate the water boiler. The thermostat can be manually operated by the user or remotely operated via z-wave to set the desired temperature level.

Transmitter

The HRT4-ZW is a battery operated wall thermostat. Using a big wheel on the device the user can preset the desired target temperature in the room. By verifying the target temperature with the measured real temperature closed to the device the unit decides how to operate a wirelessly attached power switch that is attached to the heater. In parallel a central gateway of z-Wave control software can set the target temperature using Z-Wave. This enables to realize a time scheduled zone heating. The thermostat itself does not have any internal timers but executes the wireless settings (COMMAND CLASS THERMOSTAT_SETPOINT) and the local setup.

Technical Data

• Z-Wave-Device Type: Portable Controller
• Batteries: 2 * AAA
• Temperature Precision: +/- 0.5 grd
• Temperature Range: 5 ... 30 grd
• Protection Class: IP 30
• Dimensions: 86mm x 86 mm x 36.25 mm
• Design Standard: EN60730

Receiver

The HRT4-ASR-ZW is a wirelessly controlled Relay switch to operate loads up to 3 A / 230 V. It is used to control warm water boilers or magnet valves. The device can be operated locally using two buttons. A LED indicated the current switching status. The fashionable design of the device allows mounting it on visible positions in the home.

Technical Data

• Z-Wave-Device Type: Routing Slave
• Protection Class: IP 30
• Dimensions: 86mm x 86 mm x 36.25 mm
• Design Standard: EN60730
• Max Load: 3 A on 230