The HomePro single wall switch is switching attached loads and is controlled either by the local switching paddle or remotely via the Z-Wave wireless protocol. It is included and controlled in a Z-Wave network by a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
Beside the local switch the unit can control other Z-Wave units remotely in up to three additional Z-Wave groups, which are associated with this device. Tipping one time, two times or three times the switching paddle performs the control. The locally attached load is controlled together with the Z-Wave units associated in group 1. The association of further Z-Wave devices needs to be done by a Z-Wave controller.  The unit is powered by 230V power and needs a pattress box with 230 V power wires for installation. The unit is shipped completely with electronics, switching paddle and mounting frame in arctic white HomePro style. The mounting frame can be replaced by another mounting frame of the HomePro switching series. The unit is designed for use within a 3-wire system, which means that a neutral wire (blue) is needed for operations.

Technical Data:

• Power rating: 230V, 50 Hz
• Wiring: 3-wire system
• Maximum loads: all loads up to 6 A
• Wireless behaviour: receiver and transmitter if further units are associated
• Z-Wave type: slave
• Distance:  up to 30 m in buildings
• Display: blue LED shows switching status
• Local interaction: one button for switching, inclusion, exclusion and association
• Installation: pattress box
• Power supply: via 230 V power

Manufacturers Installation Manual for ACT_ZRW230 (english)
Manufacturers Data Sheet for ACT_ZRW230 (english)